D-Link DES-3624 - Switch - Stackable User manual - Power Failure
Manual is about: Stackable NWay Ethernet
Switch
of
228
Stackable NWay Ethernet Switch User’s Guide
♦ All LED indicators will momentarily blink. This blinking
of the LED indicators represents a reset of the system.
♦ The power LED indicator will blink while the Switch loads
onboard software and performs a self-test. After
approximately 40 seconds, the LED will light
continuously to indicate the Switch is in a ready state.
♦ The console LED indicator will remain ON if there is a
connection at the RS-232 port, otherwise this LED
indicator is OFF.
♦ The 100M LED indicator may remain ON or OFF
depending on the transmission speed.
Power Failure
As a precaution, the Switch should be unplugged in case of
power failure. When power is resumed, plug the Switch back
in.
12
Unpacking and Setup