D-Link DES-3624 - Switch - Stackable User manual - page 110
Stackable NWay Ethernet Switch User’s Guide
Configure Filtering and Forwarding table screen. The
following screen appears:
Figure 6-22. Static Multicast Filtering Table Configuration screen
To make a change to the Static Multicast Filtering Table,
choose Add or Remove in the Action field. Then enter the MAC
Address and the member port numbers in the desired fields,
for example Master and Slave 1 if there are two Switches in
your stack. Press APPLY to put the changes into effect.
Configure IGMP
Internet Group Management Protocol (IGMP) allows
multicasting on your network. When IP Multicast Filtering is
enabled, the Switch can intelligently forward (rather that
broadcast) IGMP queries and reports sent between devices
connected to the Switch and an IGMP-enabled device hosting
IGMP on your network.
90
Using the Console Interface