D-Link DES-3624 - Switch - Stackable User manual - page 99
Stackable NWay Ethernet Switch User’s Guide
which you are sending the copies. Also, the target port
cannot be a member of a trunk group.
Configure Spanning Tree Protocol
The Spanning Tree Algorithm Parameters can be used for
creating alternative paths in your network. The Protocol
Parameters allow you to change the behind the scene
parameters of the Spanning Tree Algorithm at the bridge level.
The parameters for this section have been fully explained in
the previous chapter. It is recommended that you read this, as
well as the introductory section in the same chapter entitled
Spanning Tree Algorithm, before changing any of the
parameters.
STP Parameter Settings
To change the Protocol Parameters:
1. Choose Configure Spanning Tree Protocol from the
System Configuration menu. The following Configure
Spanning Tree Protocol menu will be displayed:
Using the Console Interface
79