D-Link DES-3624 - Switch - Stackable User manual - Ip Address
Stackable NWay Ethernet Switch User’s Guide
IP Address
Figure 7-1. Configure IP Address window
You can change the IP Address, Subnet Mask, and Default
Gateway on the Switch. If your are not using BOOTP, enter the
IP Address, Subnet Mask, and Default Gateway of the
Switch. If you enable BOOTP Service, you do not need to
configure any IP parameters because a BOOTP server
automatically assigns IP configuration parameters to the
Switch. Click Apply to activate the new settings.
The information above is described as follows:
♦ Management Module MAC Address The Ethernet
address for the device. Also known as the physical
address.
♦ BOOTP Service The BOOTP protocol allows IP
addresses, subnet masks, and default gateways to be
assigned on a central BOOTP server. If this option is
134 Web-Based
Network
Management