DAELIM Roadwin R Service Manual - page 11

1-7

GENERAL INFORMATION

Wire  band  must  be  secured  firmly  in  the  specified

location  of  the  frame.  In  case  of  aluminium  band,

secure the wire harness to the coated part.

Secure the wire harness firmly using the clamp.

Insert  the  connector  until  the  vinyl  cover  is  fully

inserted into the terminal.

The opening of the vinyl cover must face at the ground

direction but in case of the plain connector, the draining

opening must face at the sky direction.

When  removing  T-start,  broaden  the  groove  of  T-start

using the wiring driver and release the torque.

Connect  the  harness  and  the  hose  to  T-start  and  then

insert until the groove is locked.

When removing T-start from the frame, replace it with

the new one.

In case of the weld clamp, do not clamp in the welded

part.

When  clamping  the  wire  harness,  make  sure  that  the

harness is not contacted with the shaft or rotating part.

When  clamping  the  wire,  pay  attention  not  to  contact

with hot part.

The  wire  harness  must  be  routed  without  contacting

with the end of the lamp or any sharp edge.

The  wire  harness  must  be  routed  without  contacting

with the end of the bolt or the piece.