DAELIM Roadwin R Service Manual - Starter Magnetic Switch
19-9
ELECTRIC STARTER
STARTER MAGNETIC SWITCH
REMOVAL
Remove the seat. (
13-2)
Remove the RH. side cover. (13-2)
Disconnect the battery
wire cable from the starter
magnetic switch terminal.
Disconnect the starter motor cable from the starter
magnetic switch terrminal.
Disconnect the Yellow/Red and Green/Yellow
connector from the wire harness.
Remove the starter magnetic switch from the bracket
of the frame.
STARTER MAGNETIC SWITCH
VOLTAGE INSPECTION
Connect the starter magnetic switch connector.
Shift the transmission into neutral.
Measure the voltage between the Yellow/Red wire
terminal(+) and ground (-).
If the battery voltage appears only when the starter
switch is pushed with the ignition switch to "ON", it is
normal.
GROUND LINE INSPECTION
Disconnect the magnetic switch connector.
Check for continuity between the Green/Yellow wire
terminal and ground.
There should be continuity.
OPERATION INSPECTION
Shift the transmission into neutral.
Turn the ignition switch to "ON", and push the starter
switch button.
The coil is normal if the starter magnetic switch clicks.
If you don’t hear the switch "CLICK", inspect the
magnetic switch using the procedure below.