DAELIM Roadwin R Service Manual - Rear Cushion

15-7

REAR WHEEL/REAR SUSPENSION

Install the axle nut temporary.

By  tightening  the  chain  adjust  nut,  adjust  the  drive

chaim slack. (

2-8)

Tighten the axle nut to the specified torque.

TORQUE : 8.8 kgf

m ( 88 N

m)

REAR CUSHION

REMOVAL

Raise and support the motorcycle with main stand.

Remove the rear wheel mudguard.

Remove the rear cushion lower flange bolt.

Remove the LH. side cover. 

Loosen the rear cushion upper flange bolt, and remove

the rear cushion.

The damper unit is filled with high pressure nitrogen

gas. Do not disassemble gas damper unit.

Heating a gas-filled damper can lead to an explosive

release of pressure which can cause a serious injury.

INSPECTION

Visually inspect the rear cushion for damage.

Check for the :

- Damper rod for bend or damage

- Damper unit for deformation or oil leaks

- Cushion rubber for wear or damage

Check all the other parts for wear or damage.

If necessary, replace the rear cushion as an assembly.