DAELIM Roadwin R Service Manual - Transmission Assembly
of
295
12-9
CRANKCASE/TRANSMISSION/CRANKSHAFT
TRANSMISSION ASSEMBLY
Apply the gear and gear bush with clean engine oil
and install the main shaft and counter shaft.
Check the gears for freedom of movement or
rotation on the shaft.
Install the main shaft and counter shaft into the left
crankcase together.
MAIN SHAFT
COUNTER SHAFT
Note the installation direction of each snap ring.
Do not use the worn snap ring again.
Check the snap rings are seated in the grooves
spinning the rings. Align the end gaps of the snap
ring with the grooves of spline.
C-1 GEAR
C-3 GEAR
MAIN SHAFT
M-3 GEAR
M-4 GEAR
M-5 GEAR
M-2 GEAR
C-4 GEAR
C-5 GEAR
C-2 GEAR
DRIVE SPROCKET
COUNTER TRANSMISSION SHAFT