DAELIM Roadwin R Service Manual - Winker Relay

20-8

LIGHTS/METER/SWITCHES

WINKER RELAY

Remove the rear seat. (

13-2)

Check the following:

- Battery condition

- Burned bulbs

- Burned fuse

- Main switch and winker switch function

- Loose connectors

If the above items are all normal, check the following:

1. Short the Black and Gray terminals of the winker relay

connector with a jumper wire.

Start  the  engine  and  check  the  winker  light  by

turning the switch to ON.

Light comes on 

Light does not come on

Faulty winker relay

Poor connection of the connector

Broken wire harness

GEAR CHANGE SWITCH

Remove the seat. (13-2)

Remove the LH. side cover. (13-2)

Disconnect  the  neutral  switch  connector  from  the

switch.

Shift  the  transmission  into  neutral  and  check  for

continuity  between  the  green/white  wire  terminal  and

ground.

There should be continuity with the transmission is in

neutral, and no continuity when the transmission is into

gear.

HORN

Disconnect the wire connectors from the horn.

Connect the 12V battery to the horn terminal directly.

The horn is normal if it sounds when the 12V battery is

connected acress the horn terminals.