DAELIM Roadwin R Service Manual - page 209
15-4
REAR WHEEL/REAR SUSPENSION
SNAP RING
SNAP RING
SNAP RING
SNAP RING
SNAP RING
SNAP RING
SNAP RING
SNAP RING
SNAP RING
SNAP RING
SNAP RING
SNAP RING
SNAP RING
SNAP RING
SNAP RING
SNAP RING
SNAP RING
SNAP RING
Driven sprocket
Check the teeth of the final driven sprocket.
Replace the sprocket if worn or damaged.
DISASSEMBLY
Remove the bolts and brake disk.
Remove the dust seal.
Remove the snap ring.
Remove the nuts and final driven sprocket.
Check the drive chain and driven sprocket at the
same time.
Do not disassemble unless replacement
GOOD
REPLACE
Wheel bearing
Turn the inner race of each bearing with finger.
Bearing should turn smoothly and quietly. Also check
that the bearing outer race fits tightly in the hub.
Replace the bearings if the races do not turn smoothly
and quietly, or if they fit loosely in the hub.