DAELIM Roadwin R Service Manual - Front Master Cylinder
16-9
HYDRAULIC BRAKE
BRAKE DISK INSPECTION
Visually inspect the brake disk for damage or crack.
Measure the brake disk thickness with a micrometer.
SERVICE LIMIT : FRONT: 3.0mm
REAR : 3.0mm
Replace the brake disk if the smallest measurement is
less than the service limit.
Measure the brake disk runout with a dial indicator.
SERVICE LIMIT : 0.3mm
Check the wheel bearing for excessive play, if the
warpage exceeds the service limit.
Replace the brake disk if the wheel bearings are
normal.
Remove the bolts from the master cylinder holder and
remove the master cylinder assembly.
FRONT MASTER CYLINDER
REMOVAL
Drain the brake fluid. (16-3)
Disconnect the brake light switch wire connectors.
Remove the brake hose oil bolt and washers.
Brake fluid causes damage to the painted, plastic or
rubber parts. Do not spill fluid on these parts.
If contaminated, gently wipe off the fluid with a piece
of cloth or wash in water. Close hose joints properly to
prevent leakage of brake fluid.
BRAKE SWITCH
BRAKE SWITCH
BRAKE SWITCH
BRAKE SWITCH
BRAKE SWITCH
BRAKE SWITCH
BRAKE SWITCH
BRAKE SWITCH
BRAKE SWITCH
BRAKE SWITCH
BRAKE SWITCH
BRAKE SWITCH
BRAKE SWITCH
BRAKE SWITCH
BRAKE SWITCH
BRAKE SWITCH
BRAKE SWITCH
BRAKE SWITCH
BRAKE SWITCH
BRAKE SWITCH
BRAKE SWITCH
BRAKE SWITCH
BRAKE SWITCH
BRAKE SWITCH
BRAKE SWITCH
BRAKE SWITCH