DAELIM Roadwin R Service Manual - page 7

1-3

GENERAL INFORMATION

11. Maintenance needed to use the specialized tools must

be performed with the right tool.

12. Never  reuse  the  ball  bearing  removed  with  the  ball

applied  pressure  when  removing  press-fitted  the

bearing.

13. Check the smooth rotation of inner or outer race of the 

ball bearing by rotating  it manually.

Replace  the  ball  bearing  having  excessive  axial/

longitudinal hanging.

Wipe  the  ball  bearing  likely  to  have  hanging  with

cleaning  oil.(except  double-sided  sealed  type  ball

bearing)

Replace  the  ball  bearing  of  which  press-fitted  part  is

slacked at the case or shaft.

14. Pay  attention  to  installation  direction  in  case  of  the

single-sided  sealed  ball  bearing.  Install  the  open-

direction  or  double-sided  sealed  bearing  in  the  way

that  the  face  marked  with  manufacturer  and  size

should direct to the outer axle.

15. When  blowing  the  ball  bearing  with  compressed  air

after cleaning, keep the race from rotating. High speed

rotation of the race may damage the bearing. Prior to

installation, apply oil or grease to the bearing.

16. Install the snap ring so that chamfered side directs to

the  load-applied  side.  After  installation,  check  the

proper installation by rotating the snap ring.

17. Check  each  part  for  proper  tightening  and  operation

after installation.

18. The  brake  fluid  and  coolant  can  damage  the  painted

plastic  or  rubber  parts.  Keep  these  parts  from

contacting with them and wash these parts with water

in case of contact.

’