DAELIM Roadwin R Service Manual - page 171
12-11
CRANKCASE/TRANSMISSION/CRANKSHAFT
Make sure that there is no gap between the
mating surfaces of the right and left crankcase.
Tighten the left crankcase bolts in a crisscross
pattern in 2-3 steps.
TORQUE : 1.1kgf
m(11N
m)
After replacing the o-ring of the gear change
switch to a new one, coat the new o-ring with
engine oil, then install the switch pin into the
groove of the shift drum.
Tighten the right crankcase bolt to the specified
torque.
TORQUE : 1.1kgf
m(11N
m)
GEAR CHANGE SWITCH
GEAR CHANGE SWITCH
GEAR CHANGE SWITCH
GEAR CHANGE SWITCH
GEAR CHANGE SWITCH
GEAR CHANGE SWITCH
GEAR CHANGE SWITCH
GEAR CHANGE SWITCH
GEAR CHANGE SWITCH
GEAR CHANGE SWITCH
GEAR CHANGE SWITCH
GEAR CHANGE SWITCH
GEAR CHANGE SWITCH
GEAR CHANGE SWITCH
GEAR CHANGE SWITCH
GEAR CHANGE SWITCH
GEAR CHANGE SWITCH
GEAR CHANGE SWITCH
PIN
PIN
PIN
PIN
PIN
PIN
PIN
PIN
PIN
PIN
PIN
PIN
PIN
PIN
PIN
PIN
PIN
PIN