DAELIM Roadwin R Service Manual - page 213
15-8
REAR WHEEL/REAR SUSPENSION
BUSHING REPLACEMENT
Remove the pivot collar and dust seals.
Press out the bushing out of the rear cushion lower
mount using the special tools.
Press a new bushing into the lower mount using the
same tools.
Apply grease to the new dust seal lips, install them into
the lower mount.
Install the pivot collar.
REAR CUSHION DISPOSAL PROCEDURE
Punch the damper case center to mark drilling.
Wrap the rear cushion inside a plastic bag.
Support the rear cushion upright in a vise.
Though the open end of the bag, insert a drill motor
with a sharp 2~3mm drill bit.
Hold the bag around the drill motor and briefly run the
drill motor inside the bag; this will inflate the bag with
air from the motor and help keep the bag from getting
caught in the bit when you start.
DUST SEAL
DUST SEAL
DUST SEAL
DUST SEAL
DUST SEAL
DUST SEAL
DUST SEAL
DUST SEAL
DUST SEAL
DUST SEAL
DUST SEAL
DUST SEAL
DUST SEAL
DUST SEAL
DUST SEAL
DUST SEAL
DUST SEAL
DUST SEAL
DUST SEAL
DUST SEAL
DUST SEAL
DUST SEAL
DUST SEAL
DUST SEAL
DUST SEAL
DUST SEAL
DUST SEAL
DUST SEAL
DUST SEAL
DUST SEAL
DUST SEAL
DUST SEAL
PIVOT COLLAR
PIVOT COLLAR
PIVOT COLLAR
PIVOT COLLAR
PIVOT COLLAR
PIVOT COLLAR
PIVOT COLLAR
PIVOT COLLAR
PIVOT COLLAR
PIVOT COLLAR
PIVOT COLLAR
PIVOT COLLAR
PIVOT COLLAR
PIVOT COLLAR
PIVOT COLLAR
PIVOT COLLAR
DRILL
PLASTIC BAG
DRILLING PONT
Always wear eyes protection to avoid getting metal
shavings in your eyes when gas pressure is released.
Drilling farther into the damper case than specified
can puncture the oil chamber.