DAELIM Roadwin R Service Manual - Cylinder Head Assembly
10-10
CYLINDER HEAD / VALVES
After cutting the valve seat, apply lapping compound
to the valve face, and insert the valve with a valve
guide reamer.
Lubricate each valve stem with molybdenum grease
and insert the valve into the valve guide turning a valve
too fast can damage the stem seals.
Check to see if the valve move up and down smoothly.
CYLINDER HEAD ASSEMBLY
Install new stem seals with valve spring seat.
Do not excessively press and turn the valve to set it as it
may cause damage. Gently tap and set the valve.
The seat surface may become worn on one side if the
valve is set in the same position. Turn the valve slightly
when setting it.
Take precautions not to allow compound to get into the
clearance between the stem and guide while the valve is
being set.
FOR CYLINDER HEAD
FOR CYLINDER HEAD
FOR CYLINDER HEAD
FOR CYLINDER HEAD
FOR CYLINDER HEAD
FOR CYLINDER HEAD
FOR CYLINDER HEAD
FOR CYLINDER HEAD
FOR CYLINDER HEAD
FOR CYLINDER HEAD
FOR CYLINDER HEAD
FOR CYLINDER HEAD
FOR CYLINDER HEAD
FOR CYLINDER HEAD
FOR CYLINDER HEAD
FOR CYLINDER HEAD
FOR CYLINDER HEAD
FOR CYLINDER HEAD
Install the valve springs with the narrow pitch forward to
cylinder head.
Install the spring retainer.
Compress the valve springs and install the valve
cotters.
TOOL : VALVE SPRING COMPRESSOR
Do not compress the valve spring more than
necessary when installing the valve cotters may
cause loss of valve spring tension.
VALV E SPRING COMPRESSOR
VALV E SPRING COMPRESSOR
VALV E SPRING COMPRESSOR
VALV E SPRING COMPRESSOR
VALV E SPRING COMPRESSOR
VALV E SPRING COMPRESSOR
VALV E SPRING COMPRESSOR
VALV E SPRING COMPRESSOR
VALV E SPRING COMPRESSOR
VALV E SPRING COMPRESSOR
VALV E SPRING COMPRESSOR
VALV E SPRING COMPRESSOR
VALV E SPRING COMPRESSOR
VALV E SPRING COMPRESSOR
VALV E SPRING COMPRESSOR
VALV E SPRING COMPRESSOR
VALV E SPRING COMPRESSOR
VALV E SPRING COMPRESSOR
VALV E SPRING COMPRESSOR
VALV E SPRING COMPRESSOR
VALV E SPRING COMPRESSOR
VALV E SPRING COMPRESSOR