DAELIM Roadwin R Service Manual - Rear Master Cylinder
16-13
HYDRAULIC BRAKE
Install the RH. handle lever assembly, tighten the bolt.
Hold the bolt and tighten the nut.
INSTALLATION
Place the master cylinder assembly on the handlebar.
Align the end of the master cylinder with the punch
mark on the handlebar.
Install the master cylinder holder with the "UP" mark
facing up.
Tighten the upper bolt first, then the lower bolt.
Install the brake hose eyelet with the oil bolt and new
washers.
Tighten the oil bolt to the specified torque.
TORQUE : 3.4 kgf
m (34 N
m)
Connect the brake light switch wire connectors.
Fill the reservoir to the upper level and bleed the brake
system. (
16-7)
REAR MASTER CYLINDER
REMOVAL
Drain the rear hydraulic system. (
16-3)
Remove the rear reservoir mounting bolt.
Remove the rear brake hose oil bolt and washers.
Brake fluid causes damage to the painted, plastic or
rubber parts. Do not spill fluid on these parts.
If contaminated, gently wipe off the fluid with a piece
of cloth or wash in water. Close hose joints properly to
prevent leakage of brake fluid.
BOLT
BOLT
BOLT
BOLT
BOLT
BOLT
BOLT
BOLT
BOLT
BOLT
BOLT
BOLT
BOLT
BOLT
BOLT
BOLT
NUT
NUT
NUT
NUT
NUT
NUT
NUT
NUT
NUT
NUT
NUT
NUT
NUT
NUT
NUT
NUT
HANDLE LEVER
HANDLE LEVER
HANDLE LEVER
HANDLE LEVER
HANDLE LEVER
HANDLE LEVER
HANDLE LEVER
HANDLE LEVER
HANDLE LEVER
HANDLE LEVER
HANDLE LEVER
HANDLE LEVER
HANDLE LEVER
HANDLE LEVER
HANDLE LEVER
HANDLE LEVER
BRAKE HOSE BOLTS
BRAKE HOSE BOLTS
BRAKE HOSE BOLTS
BRAKE HOSE BOLTS
BRAKE HOSE BOLTS
BRAKE HOSE BOLTS
BRAKE HOSE BOLTS
BRAKE HOSE BOLTS
BRAKE HOSE BOLTS
BRAKE HOSE BOLTS
BRAKE HOSE BOLTS
BRAKE HOSE BOLTS
BRAKE HOSE BOLTS
BRAKE HOSE BOLTS
BRAKE HOSE BOLTS
BRAKE HOSE BOLTS
BRAKE HOSE BOLTS
BRAKE HOSE BOLTS
BRAKE HOSE BOLTS
BRAKE HOSE BOLTS
BRAKE HOSE BOLTS
BRAKE HOSE BOLTS
BRAKE HOSE BOLTS
BRAKE HOSE BOLTS
BRAKE HOSE BOLTS
BRAKE HOSE BOLTS
OIL BOLT
OIL BOLT
OIL BOLT
OIL BOLT
OIL BOLT
OIL BOLT
OIL BOLT
OIL BOLT
OIL BOLT
OIL BOLT
OIL BOLT
OIL BOLT
OIL BOLT
OIL BOLT
OIL BOLT
OIL BOLT