DAELIM Roadwin R Service Manual - Camshaft

10-3

CYLINDER HEAD / VALVES

CAMSHAFT

REMOVAL

Remove  the  noise  suppressor  cap  assembly  from

the spark plug.

Remove the side cowl.

Remove the fuel tank.

Remove the cylinder head cover bolts and cover.

Remove the AC generator cap and crank shaft hole

cap out of the left crankcase cover.

Turn the crankshaft to the left, and align the  T mark

of  the  flywheel  with  the  index  mark  of  the  LH.

crankcase cover.

Verify that the piston is located at the top dead center.

(Make all camshaft lobes face downward.)

If all camshaft lobes face upward, rotate the crankshaft

to  the  left  for  1  turn  (180 ),  and  align  the  T mark

with the index mark once again.

Loosen the cam chain tensioner screw.

Remove  the  tensioner  mounting  bolt  and  tensioner

lifter.

Remove  the  camshaft  holder  6mm  8  flange  bolts

and  remove  the  camshaft  holder  from  the

cylinderhead.

Remove the cam chain from the camshaft.

Remove the camshaft.

Take precautions not to allow the cam chain to drop

into the crankcase.