ECopy ShareScan 4.2 Installation And Setup Manual - page 126

116  

|

  Reference: Connector-specific configuration information

eCopy Connector for SMTP using LDAP

The eCopy Connector for SMTP using LDAP enables users to send scanned documents from an 

eCopy-enabled device as e-mail attachments using an SMTP server on the network. When a user 

sends e-mail from a personal SMTP account, the system prompts users to log on to validate their 

identity. The Global Address List is provided by an LDAP server.

eCopy recommends that you use the Wizard to initially configure a connector profile.

To configure the eCopy Connector for SMTP using LDAP properties:

1

In the console tree, select 

LDAP/SMTP

 > 

Properties

.

2

Select the 

Display

 tab and then specify the settings (see Table 9).

3

Select the 

Configure

 tab.

The 

Configure

 tab displays a summary of the settings that you specify using the 

Wizard

 or 

using the 

Properties

 window.

Use the 

Wizard

 to specify the basic connector settings (see Table 30).

4

Select the 

Local Address Books

 tab and then specify the settings (see Table 15 and see 

Table 16).

5

Select the 

Content

 tab and then specify the settings (see Table 10).

6

Select the 

Express

 tab and then specify the settings (see Table 11).

7

Click 

Save

, select or specify the profile name, and then click 

Save

.

Note:

Use the Properties button on the Configure tab only if you need to make custom 

modifications after the initial configuration.

Note:

This tab allows you to reate, configure, and enable an Internet address book. All the fields are 

documented in the referenced tables.