ECopy ShareScan 4.2 Installation And Setup Manual - page 75
eCopy ShareScan
®
Installation and Setup Guide
|
65
To update an existing profile:
1
In the console tree, select the connector whose profile you want to modify.
2
In the list of profiles, select the profile you want to modify.
3
Update the
Properties
settings and then click
Save
.
4
In the
Save Profile
window, select the target profile and then click
Save
.
5
Update the
Services
settings and then click
Save
.
Activating connector profiles
To make connector profiles available at a device, you activate the connectors and then select the
connector profiles. You can activate up to nine connector profiles on each device.
Each connector profile that is activated on a device is represented by a separate button on the
touch screen. While you can create as many profiles as you like for a connector, you can activate a
maximum of nine connector profiles on a single device.
To activate connector profiles:
1
In the console tree, select
Devices
>
device_name
> >
Properties
.
2
Select the
Selection
tab and then select the
Activate Connector
check box for the
connector that you want to activate.
The
Select Connector Profiles
window opens.
3
In the
Select Profiles
column, select the connector profile that you want to activate.
4
If your company uses Document Services, use the
Select a Document Service Profile
list
to select the Document Service profile that you want to associate with the connector
profile. For more information on Document Services, see page 67.
The Document Service profile name appears next to the connector profile name in the
table.
5
Click
OK
and then click
Save
.
You can only select configured profiles, which appear in black. Unconfigured profiles
appear in red.
Note:
If you update the Services settings before updating the Properties settings and you then click
Save, the Save Profile window opens. You must then select the target profile.