ECopy ShareScan 4.2 Installation And Setup Manual - Configuring A Data Source

150  

|

  Reference: Connector-specific configuration information

Configuring a data source

You can configure an existing data source or a new data source.

To configure an existing data source:

1

If the 

Select Recent Data Source

 window opens, select the data source that you want to 

use and then click 

OK

.

The 

Data Field Selector

 window opens.

2

Perform one of the following functions:

■

Map the document destination for the index fields (see page 146).

■

Map Quick Connect index fields to database fields (see page 148).

■

Set the default values for file name or index fields that will use a database as the source 

of values (see page 149).

To configure a new data source:

1

In the 

New destination

 window, click 

Configure

.

The 

Configure Data Source

 window opens.

2

Select the database type.

3

Specify the appropriate settings (see Table 42).

4

After specifying the settings, click 

Test Connection

.

5

When the system displays the “Successfully attached to the database” message, click 

OK

twice.

The 

Data Field Selector

 window opens.

6

Perform one of the following functions:

■

Map the document destination for the index fields (see page 146).

■

Map Quick Connect index fields to database fields (see page 148).

■

Set the default values for file name or index fields that will use a database as the source 

of values (see page 149).