ECopy ShareScan 4.2 Installation And Setup Manual - Driver’S Own Interface
eCopy ShareScan
®
Installation and Setup Guide
|
193
Configuring the Client to use a TWAIN
driver’s own interface
Depending on the TWAIN driver you select for use on the ScanStation Client, you may be able to
configure the Client to use the TWAIN driver's own interface.
When you select this option, the Administration console interface changes; the Scanner tab for
the device hides the scanner settings and the Use TWAIN user interface for settings option
appears on the device’s Status tab.
The Client interface changes in the following ways:
■
The icons for the scanner settings in the lower left corner of the main Client screen will not
appear.
■
When a user at the device presses a connector button, the Client will display the TWAIN
driver’s own interface. After the user specifies the scanner settings and initiates the
scanning process, the driver transfers the scanned images to the scan preview screen on the
Client.
■
When a user at the device presses the Scanner Settings button on the scan preview screen,
the Settings tab will include the Image and Output tabs, but not the Page and Scanner tabs.
To configure the Client to use the TWAIN driver’s own interface:
1
In the console tree, select
Devices
>
device_name
> >
Manage
.
2
Select the
Status
tab.
3
If you are using a Send to eCopy key that supports the use of both Send to eCopy and a
TWAIN driver, select
Enable TWAIN
.
4
Select
Use TWAIN user interface for settings
.
5
Click
Save
.