Webasto Thermo Top C Installation Instructions Manual - page 21
Other manuals for Thermo Top C:
Operating Instructions, Operating Instructions, Installation Instructions Manual, Operating And Maintenance Instructions, Installation Instructions Manual, Installation Instructions Manual, Installation Instructions Manual, Installation instructions manual, Installation Instructions Manual, Installation Instructions Manual, Installation Instructions Manual, Installation Instructions Manual, Installation Instructions Manual, Installation Instructions Manual, Installation Instructions Manual, Installation Instructions Manual, Installation Instructions Manual, Installation Instructions Manual, Installation Instructions Manual, Installation Instructions Manual, Installation Instructions Manual, Operating Instructions, Installation Instructions Manual, Installation Instructions Manual, Installation Instructions Manual, Installation Instructions Manual, Installation Instructions Manual, Installation Instructions Manual, Installation Instructions Manual, Installation Documentation, Installation Instructions Manual, Installation Instructions Manual, Installation Instructions Manual, Installation Instructions Manual, Installation Instructions Manual, Installation Instructions Manual, Installation Instructions Manual, Installation Documentation, Installation Instructions Manual, Installation Instructions Manual, Installation Instructions Manual, Installation Instructions Manual, Installation Instructions Manual
Manual is about: Typ BW50 (Benzin/Petrol/Bensin) Typ DW50 (Diesel)
of
55
Peugeot 307
Thermo Top C, E
21
RFN 2.0 l gasoline
- Cut the supplied water hose into two sections, as
shown:
1 x 80 mm + 90° bend (1)
(preassembled on the heater unit)
1 x 700 mm straight (2)
(from the 1200 mm long water hose (3) to the
original vehicle water hose / heat exchanger water
inlet).
1 x 1,200 mm + 90° bend (3)
(from the 80mm long water hose (1) to the 700mm
long water hose (2)).
- Cut the water hose supplied in the kit into three
sections, as shown:
1 x 1,150 mm + 90° bend (1)
(from the heater unit water inlet to the 580mm long
water hose (2)).
1 x 580 mm + 90° bend (2)
(from the 1,150mm long water hose (1) to the
original vehicle water hose / engine exhaust).
80
38
Section
1200
Section
3
1
2
700
Section
580
2
1
1150
39
Section
Section
Section