Webasto Thermo Top C Installation Instructions Manual - page 9
Other manuals for Thermo Top C:
Operating Instructions, Operating Instructions, Installation Instructions Manual, Operating And Maintenance Instructions, Installation Instructions Manual, Installation Instructions Manual, Installation Instructions Manual, Installation instructions manual, Installation Instructions Manual, Installation Instructions Manual, Installation Instructions Manual, Installation Instructions Manual, Installation Instructions Manual, Installation Instructions Manual, Installation Instructions Manual, Installation Instructions Manual, Installation Instructions Manual, Installation Instructions Manual, Installation Instructions Manual, Installation Instructions Manual, Installation Instructions Manual, Operating Instructions, Installation Instructions Manual, Installation Instructions Manual, Installation Instructions Manual, Installation Instructions Manual, Installation Instructions Manual, Installation Instructions Manual, Installation Instructions Manual, Installation Documentation, Installation Instructions Manual, Installation Instructions Manual, Installation Instructions Manual, Installation Instructions Manual, Installation Instructions Manual, Installation Instructions Manual, Installation Instructions Manual, Installation Documentation, Installation Instructions Manual, Installation Instructions Manual, Installation Instructions Manual, Installation Instructions Manual, Installation Instructions Manual
Manual is about: Typ BW50 (Benzin/Petrol/Bensin) Typ DW50 (Diesel)
of
55
Peugeot 307
Thermo Top C, E
9
Preassembly and installation with
manual air conditioning
NOTE:
Pay attention to the free movement of the housing
cover.
Remove any reinforcements in the relay box near the
fastening points for the blower relay and the fuse
holder.
WARNING:
When drilling, watch out for underlying components
and wires.
- Bore 2 holes of Ø 5.5 mm in the fuse and relay box.
- Fasten the fuses (1) and K3 blower relay (2) with 2
M5x12 bolts, 4 washers, and 2 M5 flanged nuts as
shown.
- Replace the F3 fuse with the enclosed 10 amp fuse.
- Connect the positive wire to the positive terminal in
the fuse and relay box.
- Connect the ground wire to the battery negative
terminal
8
1
2