Webasto Thermo Top C Installation Instructions Manual - page 25
Other manuals for Thermo Top C:
Operating Instructions, Operating Instructions, Installation Instructions Manual, Operating And Maintenance Instructions, Installation Instructions Manual, Installation Instructions Manual, Installation Instructions Manual, Installation instructions manual, Installation Instructions Manual, Installation Instructions Manual, Installation Instructions Manual, Installation Instructions Manual, Installation Instructions Manual, Installation Instructions Manual, Installation Instructions Manual, Installation Instructions Manual, Installation Instructions Manual, Installation Instructions Manual, Installation Instructions Manual, Installation Instructions Manual, Installation Instructions Manual, Operating Instructions, Installation Instructions Manual, Installation Instructions Manual, Installation Instructions Manual, Installation Instructions Manual, Installation Instructions Manual, Installation Instructions Manual, Installation Instructions Manual, Installation Documentation, Installation Instructions Manual, Installation Instructions Manual, Installation Instructions Manual, Installation Instructions Manual, Installation Instructions Manual, Installation Instructions Manual, Installation Instructions Manual, Installation Documentation, Installation Instructions Manual, Installation Instructions Manual, Installation Instructions Manual, Installation Instructions Manual, Installation Instructions Manual
Manual is about: Typ BW50 (Benzin/Petrol/Bensin) Typ DW50 (Diesel)
of
55
Peugeot 307
Thermo Top C, E
25
RFK 2.0 l gasoline
- Cut the supplied water hose into three sections, as
shown:
1 x 80 mm + 90° bend (1)
(preassembled on the heater unit)
1 x 880 mm + 90° bend (3)
(from the heater unit water inlet to the 920mm long
water hose (47/1)).
1 x 1,000 mm straight (2)
(from the 970mm long water hose (47/2) to the
original vehicle water hose / heat exchanger water
inlet).
- Cut the water hose supplied in the kit into two
sections, as shown:
1 x 920 mm + 90° bend (1)
(from the 880 mm long water hose (46/3) to the
original vehicle water hose / engine exhaust).
1 x 970 mm + 90° bend (2)
(from the 80 mm long water hose (46/1) to the
1,000mm long water hose (46/2)).
80
46
Section
880
Section
Section
2
1000
1
3
970
2
920
47
Section
Section
1
Section