Oce Arizona 600 User Manual - page 140
Océ|Printer Features Description
C-2
The amount of unused media will vary from 203.2 mm (8 inches) when operating in the
roll-to-roll printing and a job is in the print queue to 101.60 mm (40 inches) when using
the Print & Go module.
Feed Adjustment – Default “0”
This feature provides the user with the capability to adjust the media advance length
between print swaths to accommodate for slight media and site-specific variations.
Although the Arizona 600 is programmed with specific media advance parameters based on
the specific substrate being used, environmental factors, such as heat, humidity, and
different media may affect the actual optimal media advance quantity.
A “short” feed may create dark line banding in an image while a “long” feed may exhibit a
white line between print passes. When using this function, pressing the “+” key will increase
the feed number and “-” will decrease it. The range is minus 30 to positive 30. A "+" number
increases the distance of each media feed and a "-" number decreases it.
This selection is available in the Media Menu and is also available during the Load Media
process.
Condition Media – Default “OFF”
This feature is designed to assist in accurate two-sided printing where the printed media
surface tension of the first side can affect the printing of the second side. When set to ON,
the Océ Arizona 600 printer will advance the media the length of the print and rewind back
to the beginning of the image prior to printing.
This selection only appears when the printer is configured to print the
Second Side
and is
not commonly needed when printing two-sided output. This selection is located in the
Media Menu and it’s also selectable during the Load Media process.