Oce Arizona 600 User Manual - Automated Maintenance
Océ | Printer Maintenance
5-4
5.4
Automated Maintenance
The Arizona 600 printer firmware performs automated maintenance without direct
operator intervention when the printer is idle and while printing.
Plexiglas
®
Windows
Wipe clean with a lint-free cloth and 91% or
higher isopropyl alcohol only.
As required
Print & Go Drive
Roller
Wipe clean with a lint-free cloth and 91% or
higher isopropyl alcohol only (see Figure 3-18
on page 3-20).
Wipe clean with a sponge/scrubber and 91%
or higher isopropyl alcohol only (see Figure 3-
18 on page 3-20).
Every media
change
Weekly
Print Heads
Clean the nozzle plates with a lint-free swab
and cleaning fluid (for 5500/6600-series inks)
or capping fluid (for 440-series inks) according
to the Print Head Maintenance and Nozzle
Recovery Procedures document "Printer
Maintenance" on page B-1.
Use the Operator/Maintenance Menu to purge
print heads. (Note: Media must be installed
when a purge is performed.)
Daily
As required
Vacuum Platen
Wipe clean with a lint-free cloth and 91% or
higher isopropyl alcohol or cleaning fluid
(for
5500/6600-series inks) or capping fluid (for
440-series inks).
Cover the open ends with paper to improve
the vacuum when narrow media is in use.
Every media
change
As required
Ventilation and
Drying
Ensure that the airflow and ducting meet pub-
lished site survey requirements.
Every 60 days
Important:
If 91% or higher isopropyl alcohol does not remove ink stains, use only the
approved cleaning fluid (for 5500/6600-series inks) or capping fluid (for
440-series inks) supplied with the printer in very small quantities. Do not
use cleaning fluid (for 5500/6600-series inks) or capping fluid (for 440-
series inks) on the Plexiglas windows. Always use protective gloves, eye
protectors, and a lint-free cloth when handling solvent-based solutions.
Description
Procedure
Frequency