Oce Arizona 600 User Manual - Fill Reservoir

Operator

12/9/04

4-19

MAINTENANCE

fill reservoir

You will hear the waste pump running longer than the solvent pump.

Fill Reservoir

Follow these steps to manually fill a selected ink reservoir:

1.

Navigate to:

MAINTENANCE 

pump solvent

2.

Press the MENU button. You then see: 

MAINTENANCE

fill reservoir

3.

Press the ACCEPT button. You then see: 

FILL RESERVOIR 

[ color ]

Use the +/- buttons to select the required color to fill the ink reservoir.

4.

Press ACCEPT. You then see: 

FILLING [ color ]: XXX 

press CANCEL to stop

The filling process automatically stops when the ink reservoir is full. 

If you cancel before the reservoir is full, you then see:

FILL RESERVOIR 

[ color ]

Another color can be selected for filling.

5.

Press the CANCEL button twice. You then see: 

MAINTENANCE

bar code practice

Bar Code Practice

The Bar Code Practice menu enables you to practice swiping an ink bottle barcode with the 

wand attached to the printer. The wand must be held at a certain angle and moved side-to-

side over the barcode at a consistent speed. Listen for the audio beep confirmation from the 

control panel. One beep is a positive read. Two beeps is a negative read. Bar code swiping 

is required when a new or existing ink bottle is installed.