Oce Arizona 600 User Manual - Media Type: Other

Operator

12/9/04

4-23

This feature enables the adjustment of media stepping to compensate for variation 

in media lots and environmental factors. The plus direction lengthens each media 

step. The minus direction shortens each media step. 

13.

Press ACCEPT. You then see:

MEDIA MENU

hor margins: (0.2" - 4.0")

Use the +/- buttons to select the required horizontal margin value for a job.

14.

Press ACCEPT. You then see:

MEDIA MENU 

ver margins: (0.2" - 4.0")

Use the +/- buttons to select the required vertical margin value for a job.

15.

Press ACCEPT. You then see:

MEDIA MENU

[media name]

Media Type: Other

Selecting OTHER enables additional menus for manual setup. When changing values, 

holding the +/- buttons continuously increments or decrements the value repeatedly. Follow 

the steps below for this media type option:

1.

Navigate to:

MEDIA MENU 

Other

2.

Press the ACCEPT button. You then see: 

MEDIA MENU 

thickness: (2.00 - 30.00) mil

The range for thickness values is 2.00-30.00 mils. The media thickness is typically 

on the media container label, if any. The media thickness changes by .05 mils.

Use the +/- buttons to increment or decrement the thickness setting.

3.

Press ACCEPT. You then see:

MEDIA MENU 

takeup core OD: (3.10" - 4.00")

Use the +/- buttons to enter the correct core diameter. The value is increased or 

decreased in .01-inch increments. If you do not know the diameter, use a ruler and 

measure the outside diameter of the core, and enter the value in this submenu.