Oce Arizona 600 User Manual - Mandrel Assembly
Océ | Media System
3-4
3.2.4
Mandrel Assembly
Each supply and take-up mandrel assembly includes two hubs. They must be adjusted
according to the hole placement along the mandrel to center the supply and take-up media
cores. Indexing holes are provided. The user should ensure that the locking pin on the right
hub assembly is properly seated in the correct mandrel index hole.
The Arizona 600 printer accepts media from 0.91-meters to 1.9-meters (36-inches to 75-
inches) wide. Specifically, the printer can handle 75, 72, 70, 68, 66, 64, 62, 60, 54, 50, 48,
40 and 36-inch wide rolls of supply media (see Figure 3-4).
Figure 3-4 Mandrel Assembly
3/4 View of the complete Mandrel,
Stiffener, Loading Bar/Motor Assembly
Motor Assembly
Loading Bar
(Pivots)
Loading Bar Lock/Release Handle
(Pull out and turn to release the mandrel.)
Left Slide Hub Assembly
Stiffener
Mandrel Assembly
(With locator holes, see increments below.)
Mandrel Gear
Right Locking Hub Assembly
Top Bearing Lock Mechanism
(Pivots down with gravity and secures the mandrel
assembly when the loading handle is engaged.)
75
36
40
48
72
70
68
50
54
66
64
62
60
(Note: All increments in inches.)
Media Width Hub Locator Holes
Mandrel Bar Assembly
Mandrel Bearing Guide Feature
(Ensure this contact point sits on lower
bearings on drive mechanism.)
Loading Bar Gap
(Ensure this contact point rides
on the Loading Bar during
installation and removal.)
Loading Bar Space
(Ensure this contact point rides on the Loading Bar
during installation and removal.)
IMPORTANT!
The Arizona 600 is a center load printing machine. Do not attempt to left or right justify
the media during installation. Take-up cores should always be the same width as the supply media and
the loaded media should be centered on the take-up core.