Oce Arizona 600 User Manual - Configure I/0

Configure I/0

12/9/04

4-31

If the printer determines that a full bottle has been used, the following message is displayed:

Expired barcode

press ACCEPT to continue

An expired bar code can occur from changing ink bottles without scanning a new bar code 

or from additional ink being added to an installed bottle. Install a new bottle of ink and scan 

its bar code.

Press the ACCEPT button. The menu returns to step 3 (see page 4-28). You then see: 

Scan barcode (color)

Accept->Manual Entry

0.6

Configure I/0

The Arizona 600 printer has two types of data ports, Centronics

™

 parallel and low-voltage 

differential (LVD) SCSI-3. The correct configuration is typically selected by the installing 

service engineer and should not require adjustment by the customer.

0.6.1

Parallel Port Configuration

0.6.2

LVD-SCSI-3 Port Configuration

The standard 68-pin LVD-SCSI-3 port connects the printer to the PosterShop RIP 

platform via a standard 68-pin SCSI-3 data cable. The maximum length of this cable is 40 

feet (12 meters).

Follow these steps to configure the SCSI-3 port:

1.

Navigate to: 

MAIN MENU 

CONFIGURE I/O

2.

Press the ACCEPT button. You then see:

CONFIGURE I/O

active: SCSI

Note:

This port is only used by service engineers for downloading firmware.

Warning:

NEVER connect or disconnect SCSI cables with the printer or the host 

PC powered ON.