Oce Arizona 600 User Manual - Switching On Or Off

Switching On or Off

12/9/04

1-5

1.4

Switching On or Off

The printer is to be powered On/Off only by a trained and qualified service technician (see 

Figure 1-2). Position the power cord so that it does not pose a hazard when someone walks 

around or accesses the doors on the printer

Figure 1-2  Circuit Breaker Switch Location

1.5

Precautionary Measures

The battery back-up vacuum control option prevents ink from draining out of the reservoirs 

for 48 to 72 hours if an AC power outage occurs. This back-up option is intended for 

emergency

 use only. If the printer will be without power for a longer period of time, all ink 

must be flushed from the system. Contact your Customer Service representative to perform 

this function.

The battery back-up unit power switch should always be in the ON (up) position to protect 

the system and charge the battery. The battery should maintain the printer vacuum for 48 

to 72 hours. It is normal for the vacuum pump to run continuously when the printer has 

Important:

Full-time AC power is required to maintain negative pressure on the inkjet 

heads. Without this pressure, ink will drain out of the heads until the ink 

reservoirs are empty. If not rectified, permanent damage to the heads could 

occur. 

The printer may contain a battery back-up vacuum control option to 

maintain negative pressure for approximately 48 to 72 hours. This vacuum 

backup is intended for emergency use only during power outage.