Oce Arizona 600 User Manual - Media Menu

Océ | Control Panel

4-20 

To set up the Bar Code Practice menu, refer to the menu tree. Follow these steps to practice 

scanning the bar code:

1.

Navigate to:

MAINTENANCE

fill reservoir

2.

Press the MENU button. You then see:

MAINTENANCE

barcode practice

3.

Press the ACCEPT button. You then see:

BARCODE PRACTICE

Press ACCEPT to Continue

4.

Press ACCEPT. You then see:

Scan the barcode

Accept->Manual Entry

5.

Scan the ink barcode found on the side of the bottle. Listen for the sound prompts; 

single tone signifies that the barcode scan was successful whereas a double tone 

signifies an unsuccessful scan. Check the control panel after a successful scan and 

complete the ink bottle installation process. The tip of the barcode should run evenly 

across the width of the barcode including some portion of the white space. Go to the 

next step to enter it manually when scanning is unsuccessful.

6.

Press ACCEPT. You then see:

BAR CODE

->->->->->->->->->->

For manual entry, use the +/- buttons to select one symbol or letter as shown below 

the bar code on the ink bottle and press ACCEPT. Repeat this process until all 

symbols and letters are entered.

7.

Press the ACCEPT button, or press the CANCEL button. You then see:

OPERATOR 

maintenance

0.4.4

Media Menu

The Media menu enables an operator to change the type of media selected during media 

load or specify other media settings.