Oce Arizona 600 User Manual - Ink Filter Changes

Océ | Ink System 

2-4 

2.3

Ink Filter Changes

The ink filter (OIN #3012001622) can easily be changed without mess by using the 

following procedure.

The use of personal protection consistent with the safety recommendations noted at the 

beginning of this chapter is strongly recommended.

1.

Remove the ink bottle from the printer and sit on the floor near the end of the 

printer.

Gently pull the filter away from the bulkhead and out of the printer.

2.

With the new filter in hand next to old filter, remove the tube from the top of the 

old filter and place on the top of the new filter (see Figure 2-5 and Figure 2-6). 

Figure 2-5  Remove the Top Tube from the Old Filter

Note:

The ink filter must be changed after four bottles of ink have been filtered.

Note:

Observe the ink flow direction arrow on the filters for proper orientation.