Oce Arizona 600 User Manual - page 39
Roll-to-Roll Media Installation
12/9/04
3-11
9.
Turn the take-up core with the taped media one revolution (see Figure 3-14)
.
Engage
the pinch roller handle. Only the left and right pinch rollers should touch both the
media and the drive roll. Raise up all other pinch rollers.
Figure 3-14 Rotate the Take-up Core
10.
Close the top cover and the front and rear doors, and press the ACCEPT button on
the control panel. You then see:
MEDIA MENU
print side: first side
If you select the first side, go to step 14.
11.
Use the +/- buttons to select the second side. You then see:
MEDIA MENU
print side: second side
You only select this option if you are printing the second side of a double-sided
image.
12.
Press ACCEPT. You then see:
SECOND SIDE
Supply Core OD: (3.10” - 4.0”)
Use the +/- buttons to enter the correct core diameter. The value is increased or
decreased in .01-inch increments. If you do not know the diameter, use a ruler and
measure the outside diameter of the core, and enter the value in this submenu.
13.
Press ACCEPT. You then see:
SECOND SIDE
condition media: OFF
Take-up
Core
Pinch
Pinch
Roller
Raised
Raised
Roller