Oce Arizona 600 User Manual - Selecting The Media Type

Operator

12/9/04

4-21

Selecting the Media Type

The label on the end of the supply media box states the media type. If the correct media was 

not selected during media load, follow these steps to select the media you loaded:

1.

Navigate to:

MAIN MENU 

operator

2.

Press the ACCEPT button. You then see:

OPERATOR 

print parameters

3.

Press the MENU button four times. You then see: 

OPERATOR 

media menu

4.

Press ACCEPT. You then see: 

MEDIA MENU 

Media table version: XXX

The media table contains the printer set-up values that are implemented when a 

media is selected through the Media Type submenu. The version is updated by a 

separate file that typically accompanies a new firmware version.

5.

Press ACCEPT. You then see: 

MEDIA MENU

print side: first side

If you select the first side, go to step 9.

6.

Use the +/- buttons to select the second side. You then see:

MEDIA MENU

print side: second side

You only select this option if you are printing the second side of a double-sided 

image.

7.

Press ACCEPT. You then see:

SECOND SIDE

supply core OD: (3.10” - 4.0”)

Use the +/- buttons to enter the correct core diameter. The value is increased or 

decreased in .01-inch increments. If you do not know the diameter, use a ruler and 

measure the outside diameter of the core, and enter the value in this submenu.