Oce Arizona 600 User Manual - Waste Bottle Full

Operator-Performed Maintenance

12/9/04

5-5

5.5

Operator-Performed Maintenance

5.5.1

Waste Bottle Full

If the waste bottle is detected to be full, a warning message is displayed before the next print. 

This message can be overridden up to five times before it becomes a hard error message. The 

waste container must be emptied and disposed of in accordance with state and local laws or 

in accordance with the MSDS sheets.

5.5.2

Cleaning Fluid/Capping Fluid Empty

If the cleaning fluid (for 5500/6600-series inks) or capping fluid (for 440-series inks) bottle 

is detected to be empty, a warning message is displayed before the next print. This message 

can be overridden up to five times before it becomes a hard error message.

5.5.3

Cleaning the Media Drive Roller

General Cleaning

The media drive roller should be wiped clean with a lint-free cloth and 91% or higher 

isopropyl alcohol with every media change to maintain high feed accuracy and print quality.

Weekly, the media drive roller should be wiped clean with a sponge/scrubber and 91% or 

higher isopropyl alcohol only to remove any accumulated paper dust or residue.

Figure 5-1  Cleaning the Media Drive Roller

Additional Debris Removal

If too much media debris accumulates on the components, it can track back onto the media 

and ruin prints. To keep your prints clean and free of debris, routine cleaning should be 

done after each media roll change. This is especially important when using medias with 

adhesive backing. They have a coated layer that comes off easily and accumulates on various 

areas of the printer.