Oce Arizona 600 User Manual - page 47
of
148
Print & Go Media Installation
12/9/04
3-19
6.
From the front of the printer, push/pull the media towards the drive roller, making sure
it passes between the heat deflector and the drive roll (see Figure 3-11 on page 3-9). Use
the +/- buttons to add more or less media during installation.
7.
Route the media over the take-up dancer, behind the Print & Go drive roll, and up
and in-between the pinch roller bar and the Print & Go drive roll (see Figure 3-16
on page 3-19).
Before proceeding to step 8, walk behind the machine and verify that the left edge of
the media is straight on the core and that no coning or sliding has occurred.
Figure 3-16 Media Routing
Take-up
Dancer
Print & Go
Drive Roller
Pinch
Roller Bar