Oce Arizona 600 User Manual - Print Parameters

Océ | Control Panel

4-6 

0.4.1

Print Parameters

The Print Parameters menu sets up the basics of the print job, the controls for the image 

margins, and the statistics for the job.

Follow these steps to use the Print Parameters menus:

1.

Navigate to:

MAIN MENU

operator

2.

Press the ACCEPT button. You then see:

OPERATOR

print parameter

3.

Press ACCEPT. You then see:

PRINT PARAMETERS 

Statistics Menu: (on or off)

When the statistics menu is set to ON, the printer prints a set of job statistics in the 

white space below the print area. Use the +/- buttons to turn statistics ON or OFF.

4.

Press ACCEPT. You then see:

PRINT PARAMETERS

minimal maintenance during print: ON

Use the +/- buttons to change the minimal maintenance during print setting to 

OFF. The default setting is ON.

The minimal maintenance ON setting is the recommended setting and typically 

gives the best results. 

The minimal maintenance OFF setting uses different maintenance routines during 

printing.

You may want to try minimal maintenance OFF if you are having excessive 

overspray or nozzle dropout.

When disabled, the “[Min Maint: OFF]” message is included in the print statistics 

line and is displayed on the operator panel.

5.

Press ACCEPT. You then see:

PRINT PARAMETERS

double print: OFF

Use the +/- buttons to change the double print setting to ON. The default setting 

is OFF.

When the double print function is enabled (ON), the media is rewound and 

reprinted following the initial printing of the image. Prior to the second print, the