RADVision Scopia XT1000 Administrator's Manual - page 29
'Initial Configuration' | 23
RADVISION | Administrator Guide for SCOPIA XT1000 Version 2.0
Step 3
In the General page set the fields as required.
Step 4
Press
Save.
Configuring the Camera(s)
You may also access this page from a previous screen in the configuration.
Procedure
Step 1
In the Administrator settings menu select I/O connections.
Step 2
Scroll to Cameras.
Step 3
Select the HD1 or HD2 page.
Step 4
Set the fields as required.
Step 5
Press
Save.
Field Name
Description
Default camera
Specifies to which input of the Codec Unit the main camera is
connected: HD-CAM 1, HD-CAM 2, DVI. The default camera is
automatically activated when the system powers up.
Driver
Sets the camera driver for the connected camera: SCOPIA
XT1000 Standard Camera or SCOPIA XT1000 Sony Camera.
Camera control by far site
Enables/disable control of my camera(s) by the remote terminal.
Bring back to place
If enabled, the system stores camera positions when the camera
is turned off.
Name
Enter the camera’s name. The selected name will appear in the
system area of the display in addition to the camera icon.
Field Name
Description
Enable (HD1 page)
You cannot change this setting.
Enable (HD2 page)
Enables/disables HD2. If an additional camera is not used, we
recommend to disable this field.
Moving (PTZ)
Enables/disables camera’s Plan, Tilt, Zoom.
Name
Enter the camera’s name. The selected name will appear in the system
area of the display in addition to the camera icon.
White balance mode In case of lighting issues in the room, enables to select the appropriate
white balance mode. If set to Automatic, the camera adjusts
automatically to room lighting. If set to Customize, a Calibration button
appears on the display, allowing you to calibrate white balance.