RADVision Scopia XT1000 Administrator's Manual - page 70
'Troubleshooting' | 64
RADVISION | Administrator Guide for SCOPIA XT1000 Version 2.0
Step 3
Verify that the Virtual System option is enabled and that it is possible to reach the system from
the PC address. You can also enable any address or a subnet range of addresses to reach the
system.
Figure 4-2
Virtual System Configuration
Step 4
On the PC side, you need a VNC client using standard RFB v3.3 protocol. We recommend RealVNC
VNCViewer. Enter the IP address of the Codec Unit and press Enter.
Figure 4-3
PC VNC Setup
Activating Recovery Mode
The SCOPIA XT1000 Recovery Mode allows to recover the Codec Unit in case the running software
is malfunctioning or when you must reinstall the software from scratch.
The Recovery Mode can be activated in two ways: