RADVision Scopia XT1000 Administrator's Manual - page 63
'Maintenance Tasks' | 57
RADVISION | Administrator Guide for SCOPIA XT1000 Version 2.0
Step 4
Set the fields as required.
Note:
To configure the network, contact your network administrator.
Step 5
Press
Save.
Upgrading the Software
This section describes how to upgrade the software running on the Codec Unit.
Note:
Any software version can run in a temporary mode for twenty-four hours. After that period of time,
you must enter a new license key (or the license key of an older software version) in the relevant
screen.
Download a new software package from the RADVISION Web/ftp site. The software release
contains new features or patch release.
The software update package is an auto extracting file containing a specific software version (for
example: XT1000_V1_0_19.exe).
See
http://www.radvision.com/Products/Video-Conference-Systems/Conference-Room-Systems/xt1
000/xt1000registration.htm for further information.
You can update the software running on a Codec Unit in two different modes, by means of the
same software package.
In Standard mode the Codec Unit is upgraded while operating in a regular way. The standard GUI
is visible. All the configuration settings and user data are preserved in the update process.
In Recovery mode, the Codec Unit is restored to the original out-of-the-box state. All the
configuration settings and user data are erased in the update process, except the personalized
remote control code and the enabled licenses. For further information on the Recovery mode, see
Activating Recovery Mode page 64
.
Field Name
Description
Download management
Enables/disables downloading of firmware or patches to the Codec
Unit.
Enable all addresses
If set to Yes, enables access to the Codec Unit from any IP address in
a network. If set to No, configure Address and SubNet mask.
Address
Enter the IP address allowed to access the Codec Unit.
SubNet mask
Enter the SubNet mask associated with the IP address.