RADVision Scopia XT1000 Administrator's Manual - page 38
'Initial Configuration' | 32
RADVISION | Administrator Guide for SCOPIA XT1000 Version 2.0
Configuring Network Settings
Configuring Preferences
General Network Settings
This page allows you to configure the network general settings:
1.
IPv6 is supported in addition to IPv4 . There is no IPv6-only mode.
2.
Management (HTTP, SSH, FTP) is IPv4 only (even in dual mode).
3.
Media streams in the same conference can be a mixture of IPv4 and IPv6.
4.
You can configure the IPv6 address manually or automatically.
You may also access this page from a previous screen in the configuration.
Procedure
Step 1
In the Administrator settings menu select Networks.
Step 2
Scroll to Preferences.
Step 3
Select the General page.
Step 4
Set the fields as required.
Step 5
Press
Save.
Configuring Dynamic Ports
Note:
When a firewall is crossed, the firewall administrator must open a range of dynamic TCP and UDP
ports to allow bidirectional IP traffic. Moreover, once the ports have been opened, the protocols
[TCP 1720 (Q.931), TCP 1503 (T.120), UDP 1719, and 1718 (RAS)] involved in a call must be taken
into account.
Field Name
Description
Use IPv6
Enables/disables IPv6 support.
Priority
Sets GLAN/LAN priority. Specifies in which order the system will
place outgoing calls. If you acquired the LAN licence from
RADVISION, the GUI will show the LAN button.