RADVision Scopia XT1000 Administrator's Manual - page 60
'Maintenance Tasks' | 54
RADVISION | Administrator Guide for SCOPIA XT1000 Version 2.0
Step 3
In the Web page set the fields as required.
Note:
To configure the network, contact your network administrator.
Step 4
Press
Save.
Step 5
Start a web browser on your PC (Internet Explorer V7).
Step 6
Enter the Codec Unit’s IP address in the address bar of the browser.
Figure 3-1
Web Access
Step 7
Once in this page you can place a call, or change system settings as required.
Field Name
Description
Web management
Enables/disables Web access to SCOPIA XT1000 (using Telnet via IP and
ISDN connections).
HTTPS
Enables/disables https service, i.e. the Secure Socket Layer (SSL)
function.
Enable all addresses If set to Yes, enables access to SCOPIA XT1000 from any IP address in a
network. If set to No, configure Address and SubNet mask of PC (or PCs)
that should be enabled to remotely access SCOPIA XT1000.
Address
Enter the IP address allowed to access SCOPIA XT1000.
SubNet mask
Enter the SubNet mask associated with the IP address.
User name
Change the Web/Telnet default user name (Admin).
Password
Change the Web/Telnet default password (1234).