RADVision Scopia XT1000 Administrator's Manual - page 54
'Initial Configuration' | 48
RADVISION | Administrator Guide for SCOPIA XT1000 Version 2.0
Step 7
By default, Automatic Service is selected and the default value of the service is set to 81. You
may change this automatic service value by using the advanced interface available at
Administrator settings > Calls > Preferences > ISDN page.
Figure 2-12
Automatic Service Mode
In certain cases, the service values must be configured more extensively - for example, when
iVIEW and a gatekeeper are used in the network architecture. In this case, you may select the
option Service Mode >Manual, and the user interface will change as shown in the figure. This
interface will allow to configure the services for any possible value of the connection rate.
Figure 2-13
Manual Service Mode
Step 8
Press
Save.