RADVision Scopia XT1000 Administrator's Manual - page 65
'Maintenance Tasks' | 59
RADVISION | Administrator Guide for SCOPIA XT1000 Version 2.0
Managing the Codec Unit with AT Commands
You can manage the Codec Unit from a Personal Computer using AT messages over a TCP/IP
connection. The AT messages can be used for:
•
Initialization
•
Configuration
•
Call control and multipoint control
•
Control and indication
•
Diagnostics
The message exchange between RTE and PC is based on ASCII characters. Messages are sent over
a TCP socket, to the 55003 port of the RTE IP address.
Before using this functionality, you must enable AT command management in the terminal. Ask
customer support for information on the use of AT commands.
Figure 3-5
AT Control Interface
Procedure
Step 1
In the Administrator settings menu scroll to Utilities.
Step 2
Select Remote access.
Step 3
Select the AT commands page.