RADVision Scopia XT1000 Administrator's Manual - page 46
'Initial Configuration' | 40
RADVISION | Administrator Guide for SCOPIA XT1000 Version 2.0
Procedure
Step 1
In the Administrator settings menu select Networks.
Step 2
Scroll to GLAN/LAN.
Step 3
Select the Addresses page.
Step 4
Set the fields as required.
Step 5
Press
Save.
Configuring MTU Parameters
Settings are for GLAN and LAN connections.
The setting should match the network settings to avoid fragmentation. If the system or the other
party (another endpoint or a conferencing server)uses packets that are larger than the MTU size,
packets will be dropped and packet loss will occur. To avoid this loss, decrease the MTU. If packets
are smaller than the MTU size, increase the MTU.
A maximum and minimum value are displayed in this page. The maximum and minimum values
depend on selecting IPv4 or IPv6. (See
General Network Settings page 32
.) Both for IPv4 and IPv6
the MTU size is set by default to 1360 octets, and it may have these ranges:
•
The minimum allowed for IPv4 is 576 octets.
•
The minimum allowed for IPv6 is 1280 octets.
•
The maximum allowed for both is 1500 octets
Procedure
Step 1
In the Administrator settings menu select Networks.
Step 2
Scroll to GLAN/LAN.
Step 3
Select the Parameters page.
Step 4
Set the field as required.
Step 5
Press
Save.
Field Name
Setting
Enable
Enables/disables the bandwidth option.
Max. bandwidth rx (KB)
Indicates the maximum receive bandwidth.
Max. bandwidth tx (KB)
Indicates the maximum transmit bandwidth.
Field Name
Setting
MTU
Sets the maximum size of each data packet.