RADVision Scopia XT1000 Administrator's Manual - page 49
'Initial Configuration' | 43
RADVISION | Administrator Guide for SCOPIA XT1000 Version 2.0
Step 5
Press
Save.
Configuring Gateway Use
To configure the gateway, see
Configuring Network Addresses page 38
.
Configuring DNS Server Use
To configure the DNS server, see
Configuring Network Addresses page 38
.
Configuring SIP Server Use
Procedure
Step 1
In the Administrator settings menu select Protocols.
Step 2
Scroll to SIP.
Step 3
Select the General page.
Step 4
Set the fields as required.
Step 5
Press
Save.
Field Name
Description
Alias
Specifies the name that the terminal uses to register with the SIP
servers.
Password
Specifies the terminal’s password.
Use registrar
If set to Yes, enables to run terminal registration at a SIP
Registrar Server.
Server
Enter the IP address of the SIP Registrar Server.
Use proxy
If set to Yes, enables the use of a SIP Proxy Server.
Server
Enter the IP address of the SIP Proxy Server.
Server type
Choose the type of server you wish to connect to (e.g.: CISCO
UCM, Microsoft OCS, etc.). Optional for interoperability issue.
Protocol type
Specifies the preferred transport for outgoing calls (UDP or TCP).
Port
Sets the port for server signaling (default is UDP and TCP 5060).