RADVision Scopia XT1000 Administrator's Manual - page 47
'Initial Configuration' | 41
RADVISION | Administrator Guide for SCOPIA XT1000 Version 2.0
Configuring Gatekeeper Use
General Settings
Procedure
Step 1
In the Administrator settings menu select Protocols.
Step 2
Scroll to H.323.
Step 3
Select the General page.
Step 4
Set the fields as required.
Step 5
Press
Save.
Settings for Gatekeeper Use
Procedure
Step 1
In the Administrator settings menu select Protocols.
Step 2
Scroll to H.323.
Step 3
Select the Gatekeeper page.
Field Name
Description
Name H.323
H.323 ID. Specifies the name that the terminal uses to register
with the gatekeeper.
Number H.323
E.164. Identifies the number that the terminal uses to register
with the gatekeeper.
Refuse calls by IP address
If set to Yes, the gatekeeper will discard incoming calls by IP
address. The gatekeeper will only accept incoming calls by alias.
The alias must be registered with the gatekeeper.