RADVision Scopia XT1000 Administrator's Manual - page 37

'Initial Configuration' | 31

RADVISION | Administrator Guide for SCOPIA XT1000 Version 2.0

Step 3

Set PODS to output to Yes.

Step 4

Select Monitor > General.

Step 5

Set Number of Monitors to HD2.

Step 6

Press  

Save.

Upgrading to the XT1000 with Embedded MCU

Procedure

Step 1

Purchase the MCU4 or MCU9 option. 

Note:

We recommend purchasing the High Bandwidth Option (12Mbps) when using the 

embedded MCU. If the High Bandwidth option is not enabled, the MCU will send out a 

lower resolution according to the standard 4Mbps total bandwidth.

Step 2

Enable the license as explained in 

Installing and Enabling an Option License page 13

. 

Step 3

Set up a call to check how the system works.