RADVision Scopia XT1000 Administrator's Manual - page 45
'Initial Configuration' | 39
RADVISION | Administrator Guide for SCOPIA XT1000 Version 2.0
Step 4
Set the fields as required.
Step 5
Press
Save.
Configuring Bandwidths
When the system is set to Sharpness mode (see
Configuring Video Quality page 51
), it can
communicate using HD 720p starting with as low as 512Kbps.
The system continuously monitors the actual bandwidth available. Thus, if the connection
bandwidth decreases below 512Kbps, the system will automatically decrease the resolution used.
If more bandwidth becomes available, the system will dynamically increase the resolution back.
To use 1080p in the system, the connection speed has to be 1.7Mbps or above. If the connection
bandwidth decreases below 1.7Mbps, the system dynamically changes the resolution to 720p
instead of 1080p. When the available bandwidth increases back to 1.7Mbps or above, the system
returns to 1080p.
The sender determines the bandwidth for Dual Video configuration. For the system, it is always
fixed as 50% of the total call video bandwidth.
We recommend enabling the High Bandwidth Option (12Mbps) when using the embedded MCU. If
the High Bandwidth option is not enabled, the MCU will send out a lower resolution according to
the standard 4Mbps total bandwidth.
Field Name
Setting
MAC address
This setting cannot be changed.
Automatic IP address
Set to Yes (default) if the system gets its IP address automatically. If
the Codec Unit is connected to the Internet and you must set up a
static public IP address in the IP address field, set this field to No; the
other fields in this page become programmable.
IP address
If the system gets its IP address automatically, indicates the IP address
assigned to the system. Otherwise enter the system static IP adress
here.
Subnet mask
If the system gets its IP address automatically, indicates the subnet
mask assigned to the system. If you entered the system’s IP address
manually, type the subnet mask.
Gateway IP address
If the system gets its IP address automatically, this field indicates the
gateway IP address assigned to te system. If you entered the system’s
IP address manually, type the gateway IP address.
DNS server IP address If the system gets its IP address automatically, this field indicates the
DNS server IP address assigned to te system. If you entered the
system’s IP address manually, type the DNS server IP address.